General Power Tool Safety Warnings; Rotary Hammer Safety Warnings - Makita HR3200C Manual De Instrucciones

ENGLISH (Original instructions)
1. Switch trigger
2. Lamp
3. Adjusting dial
4. Quick change chuck for SDS-plus
5. Change cover
6. Chuck cover
7. Spindle
8. Quick change drill chuck
9. Lock button
SPECIFICATIONS
Concrete
Capacities
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to EPTA-
Procedure 01/2014, are shown in the table.
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General power tool safety
warnings
WARNING: Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Explanation of general view
10. Pointer
11. Change lever
12. Power-ON indicator lamp (green)
13. Service indicator lamp (red)
14. Side grip
15. Bit shank
16. Bit grease
17. Bit
18. Depth gauge
Model
Tungsten-carbide tipped bit
Core bit
Steel
Wood
-1
)
Blows per minute
Overall length
Net weight
Safety class
HR3200C
4.8 - 5.2 kg
ROTARY HAMMER SAFETY
ENE044-1
WARNINGS
Safety instructions for all operations
ENF002-2
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold the power tool by insulated gripping
surfaces, when performing an operation where the
cutting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
GEA010-2
and could give the operator an electric shock.
Safety instructions when using long drill bits with
rotary hammers
1. Always start drilling at low speed and with the bit
tip in contact with the workpiece. At higher speeds,
the bit is likely to bend if allowed to rotate freely
without contacting the workpiece, resulting in personal
injury.
2. Apply pressure only in direct line with the bit and
do not apply excessive pressure. Bits can bend,
causing breakage or loss of control, resulting in
personal injury.
Additional safety warnings
1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
19. Clamp screw
20. Dust cup
21. Blow-out bulb
22. Chuck adapter
23. Keyless drill chuck
24. Sleeve
25. Ring
HR3210C
32 mm
90 mm
13 mm
32 mm
315 - 630
1,650 - 3,300
398 mm
5.2 - 5.6 kg
/II
HR3210FCT
424 mm
5.4 - 5.6 kg
GEB243-1
5