Publicidad
Idiomas disponibles
Idiomas disponibles
Drilling with a Core Bit (Fig. A, B)
1.
Insert the appropriate core bit.
2.
Assemble the centerdrill into the core bit.
3.
Set the mode selector switch
position.
4.
Turn the electronic speed and impact control dial
a medium or high speed setting.
5.
Fit and adjust the side handle qs.
6.
Place the centerdrill on the spot and switch on the
tool. Drill until the core penetrates into the concrete
approximately 1 cm.
7.
Stop the tool and remove the centerdrill. Place the core bit
back into the hole and continue drilling.
8.
When drilling through a structure thicker than the depth of
the core bit, break away the round cylinder of concrete or
core inside the bit at regular intervals.
To avoid unwanted breaking away of concrete around
the hole, first drill a hole the diameter of the centerdrill
completely through the structure. Then drill the cored hole
halfway from each side.
9.
Always turn the tool off when work is finished and before
unplugging.
Chipping and Chiselling (Fig. A, B)
1.
Insert the appropriate chisel and rotate it by hand to lock it
into one of 18 positions.
2.
Set the mode selector switch
position.
3.
Set the electronic speed and impact control dial 8.
4.
Fit and adjust the side handle qs.
5.
Turn the tool on and start working.
6.
Always turn the tool off when work is finished and before
unplugging.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
to the rotary hammering
3
to
8
to the 'hammering only'
3
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and
around the air vents. Wear approved eye protection and
approved dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these
parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by BTI, have not been tested with this product, use of
such accessories with this tool could be hazardous.
To reduce the risk of injury, only BTI recommended
accessories should be used with this product.
Various types of SDS MAX drill bits and chisels are available as
an option. Accessories and attachments used must be regularly
lubricated around the SDS MAX fitment.
Consult your dealer for further information on the appropriate
accessories.
Protecting the Environment
Separate collection. Products marked with this symbol
must not be disposed of with normal household
waste.
Products contain materials that can be recovered or
recycled reducing the demand for raw materials.
Please recycle electrical products according to local provisions.
Further information is available at www.BTI.de.
English
25
Publicidad
