Targa Dati - Telwin SUPERIOR 630 CE VRD Manual De Instrucciones

sheets without having to beat them on the reverse. This is essential in
the case of bodywork that cannot be accessed from the rear.
The operation is carried out as follows:
for the nail on the side.
their original state. The procedure consists of heating the sheet to
be drawn up to a temperature of approx. 800° C and then cooling it
rapidly with a cloth soaked in water.
knob.
- Release pressure from the wire feed by unhooking the spring to
prevent the wire from being dragged on the torch.
Place the end part of
7. MAINTENANCE
ROUTINE MAINTENANCE OPERATIONS CAN BE CARRIED OUT
BY THE OPERATOR.
Torch
- Do not put the torch or its cable on hot pieces; this would cause the
short time;
hose using dry compressed air (max. 5 bar) to make sure it is not
damaged;
area (rollers and wire-guide infeed and outfeed).
EXTRAORDINARY MAINTENANCE
EXTRAORDINARY MAINTENANCE MUST ONLY BE CARRIED
THE ELECTRIC-MECHANICAL FIELD, AND IN FULL RESPECT
OF THE IEC/EN 60974-4 TECHNICAL DIRECTIVE.
If checks are made inside the welding machine while it is live,
this may cause serious electric shock due to direct contact with
the electrode in contact
dry compressed air (max. 10 bar).
- Do not direct the jet of compressed air on the electronic boards;
these can be cleaned with a very soft brush or suitable solvents.
check the wiring for damage to the insulation.
welding machine and screw the fastening screws right down.
is open.
not come into contact with moving parts or parts that can reach high
to keep the high voltage connections of the primary transformer
separate from the low voltage ones of the secondary transformer.
Use all the original washers and screws when closing the casing.
PRIMA DI UTILIZZARE
with
ATTENTAMENTE IL MANUALE DI ISTRUZIONE.
1. SICUREZZA GENERALE PER LA SALDATURA AD ARCO
Attenersi scrupolosamente alle norme relative alla sicurezza
riportate nel manuale del generatore.
Le protezioni
collegare la saldatrice alla rete di alimentazione.
- Pulizie dei rulli, degli ingranaggi e della zona sottostante ad
essi;
DEVE ESSERE ESEGUITO CON LA SALDATRICE SPENTA E
SCOLLEGATA DALLA RETE DI ALIMENTAZIONE.
- È vietato utilizzare la maniglia come mezzo di sospensione
della saldatrice.
2. INTRODUZIONE E DESCRIZIONE GENERALE
ALIMENTATORE DI FILO
2
saldare.
3. DATI TECNICI

3.1 TARGA DATI

- 7 -
I
MANUALE ISTRUZIONE
L'ALIMENTATORE
e le parti mobili
2
Fig. A
LEGGERE
dell'involucro