Black and Decker KA2000 Manual De Instrucciones página 6

ENGLISH
Item Description
240 grit large detail sanding sheet with two
replacement tips.
For a fine finish for large detail sanding.
(Part Number - X31019-XJ)
120 grit large detail sanding sheet with two
replacement tips.
For a medium finish for large detail sanding.
(Part Number - X31009-XJ)
60 grit large detail sanding sheet with two
replacement tips.
For a coarse finish for large detail sanding.
(Part Number - X31039-XJ)
120 grit detailed finger sanding sheet.
For a medium finish for detailed sanding.
(Part Number - X3277-XJ)
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting sanding mesh (fig. A)
Hold the tool with the sanding base facing upwards.
u
Place the sanding mesh (5) onto the sanding base, mak-
u
ing sure that the holes in the sheet line up with the holes
in the base.
Fitting sanding sheets (fig. B - Optional accessory)
Detach the two additional diamond-shaped tips (7) from
u
the sanding sheet (6).
The diamond-shaped tip (7) can be reversed and replaced
when worn.
When the front part of the tip is worn, detach it from the
u
sheet, reverse it and press it onto the sanding base again.
When the whole tip is worn, remove it from the sanding
u
base and fit a new tip.
For optimal dust collection, ensure the correct type of sanding
paper is used.
Finger attachment (fig. C)
The finger attachment is used for fine detail sanding.
Remove the screw (9).
u
Remove the diamond-shaped tip (8) from the sanding
u
base.
Fit the finger attachment (4) onto the sanding base.
u
Fit and tighten the screw.
u
6
(Original instructions)
Fit the appropriate sanding sheet onto the finger attach-
u
ment.
Fitting and removing the dust cassette (fig. D)
Slide the dust cassette (2) onto the tool and make sure
u
that it is securely located.
To remove the dust casette, pull it to the rear and off the
u
tool.
Use
Warning! Let the tool work at its own pace. Do not overload.
Switching on and off
To switch the tool on, slide the on/off switch (1) to the
u
forward position I.
To switch the tool off, slide the on/off switch (1) to the back
u
position O.
Emptying the dust cassette (fig. D, E & F)
The dust cassette should be emptied every 10 minutes of use.
While holding the tool, pull the dust cassette (2) off the
u
tool.
Remove the cassette lid (10).
u
Shake the lid (10) and dust cassette (2) to empty the
u
contents, the filter (11) inside the lid (10) can be cleaned
with a soft dry brush.
Refit the lid (10) to the dust cassette (2).
u
Refit the dust cassette (2).
u
Maintenance
Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance, switch off and
unplug the tool.
Regularly clean the ventilation slots in your tool using a
u
soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the new
u
plug.
Connect the blue lead to the neutral terminal.
u
Warning! No connection is to be made to the earth terminal.
Follow the fitting instructions supplied with good quality plugs.
Recommended fuse: 5 A.