TRAPP JK-500 Manual De Instrucciones página 31

Additional Safety and Operation Instructions
Make sure the voltage of the power source
✔
is the same of that of the equipment.
✔ Carefully read instructions and get familiar
with the controls and proper used of the
equipment.
✔ Remember that the operator or user is
responsible for any accident or damage
involving people or their properties.
✔ Do not operate the equipment barefooted or
with sandals.
✔ Always wear adequate shoes and pants,
goggles, gloves and ear plugs.
Avoid operating the equipment in humid
✔
places.
✔ Use the equipment in a well lit
environment.
Before feeding any kind of foliage, start the
✔
motor and wait for it to reach maximum
revolution.
Do not introduce anything in the equipment
✔
with the motor off.
✔ Do not use the equipment during periods of
power supply failure.
Whenever cleaning or servicing, make sure
✔
the motor is off and the blade is still. Then
unplug the equipment.
If the equipment starts to vibrate, turn it off
✔
and immediately unplug it. Check the cause
of the vibration as it indicates that the
equipment needs adjustment and repair.
Attention!
Frequently check if all screws are well
tightened, mainly the counter cutting
blade one. Always keep the counter
cutting blade adjusted to assure the
good performance of the equipment.
Check the status of the power supply cord.
✔
Never fix it with insulating tape.
✔ Never use a water jet to clean the
equipment. Use a damp cloth and detergent
neutral. Water inside the equipment can
damage the electric circuit of the motor,
besides increasing the risk of an electric
shock.
✔ Never operate the equipment with the cover
open or without the belt protection guard.
Attention!
When the equipment is in operation,
do not put your hand inside of the
foliage funnel, the palm (cacti) supply
funnel or in the lower outlet.
Attention!
Whenever cleaning or servicing, make
sure the equipment is off and the
blades are still as they continue to
move for some seconds.
29