Useful Suggestions - TRAPP JK-500 Manual De Instrucciones

Throghout the use of the equipment situations and or problems may occur, for which
we present some suggestions:
Trouble Probable Cause
Equipment Excess feeding or overload.
Jammed Due to this motor cannot
achieve required rotation, and
the material accumulates in the
equipment (continuous use
under this condition, can cause
motor burn-out due to
overload).
Low 1 - Insufficient feeding of the
Production
2 - Motor rotation lower than
3 - Moist or green produce.
4 - Adjustment on equipment
Irregular 1 - Dull cutting blades.
Chopping
2 - Worn or unbalanced.
Difficulty 1 - Excess or overload of
Starting Motor
2 - Drop of high tension or

Useful Suggestions

equipment.
specified.
is not consistent with the
material in use.
produce.
power source.
Solution
Turn OFF equipment immediately and wait
for motor to stop. Open hatch and remove the
excess material inside equipment, close
hatch. Once equipment is ready to operate,
turn ON the motor, and wait until rotation
reaches its full speed, only then resume work.
Maintain a steady and regulated amount of
input, so as not to overload motor.
1 - Maintain a continuous feeding flow, yet
not over-feeding which may cause the
equipment to jam.
2 - Verify if purchased motor to be
installed on equipment (equipment sold
without motor) is compatible accoding to
specifications (see sticker on equipment).
If motor rotation is below specification,
the hammers will be delayed causing low
production.
3 - When using funnel only grind dry grains
and/or dry produce. Grinding moist or
green grains/produce will clog and
obstruct strainer.
4 - Select different strainer for your choice
application (coarse or fine).
1 - Sharpen cutting blades
(see page 36).
2 - Follow procedure indicated on page 35.
1 - Turn OFF equipment immediately and
wait for motor to stop. Open hatch and
remove the excess material inside
equipment, close hatch. Once equipment
is ready to operate, turn ON the motor,
and wait until rotation reaches its full
speed, only then resume work
2 - Consult electrician to check power
source.
37