Arregui CLASS Manual Del Usuario página 8

CAUTION
Do not keep the keys in the safe itself.
1. OPENING THE SAFE
To open the safe first time, remove the small plastic cover ("B",
see diagram 1) on the front panel, insert the key into the key
hole and turn it counter-clockwise direction, at the same time,
turn the doorknob ("A", see diagram 1) clockwise direction to
open the safe.
A
Diagram 1
2. INSTALLING THE BATTERIES
The safe requires 4×size "AA" (1.5V) batteries.
Open the safe, push the battery cover plate "D" (see diagram
2) on the back of the door and install the batteries. Ensuring
the batteries are fitted with the correct corresponding polarity.
Use of alkaline batteries is recommend.
3. PROGRAMMING THE CODE
A. With the safe door open, press the red button "C" (see
diagram 2) on the back of the door near the hinge, release it
and you will hear two beep. The yellow light will be on at the
same time.
B. Now press from 3 to 8 numbers that you wish to use as a
combination, and confirm by pressing the letter "A" or "B"
within 15 seconds. The safe "bleeps" twice and the yellow
light will go off, your personal code is now set.
C. Write down your new combination immediately and check
whether your new combination has been programmed or
not on conditions of the safe door open.
4.USING YOUR SAFE
To open the safe, enter your personal code followed by the letter
"A" or "B", you will hear a beep and the green light will be on, then
turn the doorknob in clockwise direction to open the door within
5 seconds.
If you or an intruder uses the incorrect group of numbers,
it will not open. If the incorrect combination is used 3
times consecutively, you must wait for 20 seconds before
reattempting.
B
If again the incorrect combination is selected 3 times, you must
wait approximately 5 minutes before reattempting access.
5. BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (in the middle of the number
panel) will warn you immediately. To test the batteries, just
input your personal numbers to open the door. If the batteries
are low, the red light will be on. If nothing happens, it means that
the batteries are in order.
6. REPLACING THE BATTERIES
The safe requires 4×size "AA" (1.5V) batteries.
Open the safe, push the battery cover plate "D" (see diagram 2)
on the back of the door and replace the 4 PCS old batteries. You
must reprogram the code, using the above third step.
Use of alkaline batteries is recommended.
7. OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, we have engineered a manual
override system for your safe. If you forget or misplace your
combination, remove the small central plate on the front panel
( "B", see in diagram 1) , insert the key into the keyhole and turn
it in a counter-clockwise direction, then turn the knob ("A", see in
diagram 1) in a clockwise direction towards the right. This will
manually open your safe at any time.
8. INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured to floor,
wall or in a cupboard. For your convenience, there are holes
(diameter 8mm) on the back and in the bottom; therefore it can
be fixed by the expansion bolts .
CAUTION: The safe should be placed horizontally when
installing the safe.
Please refer to diagram 2 for reference:
9.
MAINTENANCE
Check the condition of the battery compartment on a regular
basis (every 6 months) to identify any possible signs of rust,
sulphation, etc.
Grease/oil any mechanical moving parts, such as locks and
bolts.
Diagram 2
En
C D