Publicidad
Idiomas disponibles
Idiomas disponibles
If the appliance is to be used as a 130 cm high standing fan
• Unpack the fan and remove all parts of the package.
• Insert the lower tube (16) into the hole in the base (17), place
the washer (18) under the base and tighten the base with the
L-screw (19) clockwise.
• Insert the intermediate tube (14) into the center of the lower
tube (16), align the screw in the screw holes and tighten both
tubes with the screw provided (15).
• Insert the fan head together with the upper tube (10) into the
centre of the intermediate tube (14) and align the screw hole,
screw and tighten with the screw provided (12).
• Use the fixing nut (6) to attach the rear grille (7) to the fan
head (9). Then use the blade retaining nut (4) to secure the
fan blade (5).
• To place the front grille on the rear grille, you must use the
grille ring to keep both parts together. Tighten the ring with
the screw provided once the grilles are properly positioned.
If the appliance is to be used as a 90 cm stand fan
If the fan is to be used as a 90 cm high foot fan, remove parts 12
and 14 from the assembly.
If the appliance is to be used as a table-top fan
If the fan is to be used as a table-top fan, remove parts 12, 14, 15
and 16 from the assembly.
4. USING YOUR APPLIANCE
Before using the fan, make sure it is on a flat, stable surface.
Damage may occur if the fan is placed on a slope.
NOTE: Before inserting the plug into a power outlet, make
sure that the voltage corresponds to the one indicated on the
23
Publicidad
