Publicidad
Idiomas disponibles
Idiomas disponibles
Use the following procedure to route the
connecting cable:
1.
Route the connecting cable in the direction of
the cable grommet, away from the machine.
➢
For support, use the Velcro fastener on
the hose connector.
2.
Always keep the connecting cable as far away
as possible from the tool.
✓
Connecting cable routed.
4.3 Chip extraction
For all work that produces a significant amount of dust, connect the machine to a suitable external extraction
device. The air velocity must be at least 20 m/s [65 ft/sec].
The inner diameter of the hose connector is 58 mm [2.3 in].
4.4 Saw blade selection
To achieve good cutting quality, use a sharp tool and select a tool from the following list that is appropriate for
material and application:
Cutting softwood and hardwood across the grain direction, plywood, chipboard and wood-core
plywood:
- Carbide circular saw blade Ø 330 x 3.6 x 30 mm, 40 teeth [Ø 13 x 0.14 x 1.2 in]
Cutting softwood and hardwood along the grain direction:
- Carbide circular saw blade Ø 330 x 3.2 x 30 mm, 24 teeth [Ø 13 x 0.13 x 1.2 in]
Cutting composite material:
- Carbide circular saw blade Ø 330 x 2.6 x 30 mm, 54 teeth [Ø 13 x 0.1 x 1.2 in]
alternating teeth with bevel
14
Caution
Health hazards from wood dust
The dusts produced during work can be inhaled and can cause health damage.
Harmful dust must be extracted with a HEPA 13 dust extractor.
➢
Wear a dust mask during work.
➢
Fig. 6: Routing the connecting cable
MKS130Ec
01/2022
Publicidad
