Assembly; Set Up And Operation - Shop-Vac 970C Manual Del Usuario

BAND DOLLY
1. Place casters into sockets on band assembly.
2. Place tank upside down and slip band assembly over lip on bottom of tank.
3. Insert bolt and tighten nut until secure.
4
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. Refer to the filter installation and maintenance section to make sure the correct filters are installed for
your cleaning operation.
2. Replace tank cover. Make sure each latch or clamp is secured over the raised area of the tank cover.
Failure to properly secure the latches could cause the tank cover to release from the tank.
3. Install machine hose end into inlet located on the top of the tank lid.
4. Attach the desired cleaning accessory onto the accessory end of the hose. NOTE: Many more useful tools
are available at your local dealer or the Shop-Vac
5. Plug the cord into the wall outlet. Your cleaner is ready for use.
I = ON, O = OFF
ACCESSORIES, HOSES AND WANDS
All Shop-Vac vacuums covered in this manual come with accessories to cover wet and dry cleanup jobs.
®
Not all vacs include all accessories shown.
Nozzles and Accessories
Lock
Lock
Carpet
Tool
Insert
Double
Blade
Squeegee
Insert
Floor
Brush
Insert
14" (35.56cm) ABS Plastic
Master Nozzle
Inserts lock into place by
sliding red buttons. Elbow swivels.
Carpet
Tool
Insert
Squeegee
Insert
Deluxe 12" (30.48cm) Nozzle
Inserts snap-in and out.
Elbow swivels.

ASSEMBLY

1. 55 Gal. band assembly
2. Caster
1
2
3

SET UP AND OPERATION

–
This equipment incorporates parts such as switches, motors or the
(1.25" (3.18cm)
utility nozzle
shown)
All Friction Fit
Accessories
Insert wand end or hose
into accessory and twist to
form a tight fit.
Brush Insert Shown
14" (35.56cm) Metal
Master Nozzle
Inserts lock into place by
sliding insert onto nozzle.
Dual Surface Selector Nozzle
Levers control brush position for
various types of cleaning.
ITEM NUMBER & DESCRIPTION
website.
®
Hoses
All Friction Fit Hoses
Insert machine hose end into
tank and twist to form a
tight fit.
Posi-Lock Hoses
Insert hose collar onto
threaded tank inlet and
tighten. Do not over-tighten.
3. Hex head bolt, ¼ - 20 x 1¾
4. Hex nut, ¼ - 20
Wands
All Friction Fit Wands
Insert wand ends together
and twist to form a tight fit.
Positive Locking Wands
Insert wand ends together
until metal push button locks.
Locking Nut Wand End
Insert wand end over nozzle
and tighten nut.
PAGE 5