Unpacking; Assembly - Shop-Vac SL14-350A Manual Del Usuario

UNPACKING

Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature that may
have been packed in the vacuum tank.

ASSEMBLY

CASTER SYSTEM
ASSEMBLY
1. You will find four casters
FIGURE 1, four caster feet
FIGURE 2, and four screws
with your wet/dry vacuum.
FIGURE 1
FIGURE 2
Assemble as follows:
2. With cord disconnected from receptacle and tank
cover removed, turn tank upside down so that bottom is
facing up. Remove any webbing that attaches the caster
feet to each other.
3. With front of tank inlet facing
you, take caster feet marked
with the letter A. FIGURE 3
and insert stem of caster foot
into holes on left front and right
rear of tank also marked with the
letter A. FIGURE 4.
FIGURE 3
A
A
FIGURE 4
4. Make sure caster feet are fully
inserted into tank bottom and
secure with screws provided.
B
FIGURE 5
FIGURE 5
B
B
FIGURE 6
B A
B
B
B
A
FIGURE 7
6. Make sure caster feet are fully
inserted into tank bottom and
secure with screws provided.
FIGURE 8
FIGURE 8
7. Insert casters into feet by
placing stem of caster into holes
provided. Apply pressure and
twisting motion until casters
snap into place
Return tank to upright position.
FIGURE 9
TOOL HOLDER
ASSEMBLY
FIGURE 10
.
5. Take caster feet marked with
FIGURE 6
the letter B.
insert stem of caster foot into
holes on right front and left rear
of tank also marked with the
FIGURE 7
letter B. .
.
FIGURE 9
8. With rear of unit facing you,
take tool holder and position it
with tabs facing rear of unit.
FIGURE 10
.
and
.
PAGE 5