Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
13. Attach handle (MM) to drawer front (S) using
5/32" x 15 mm bolts (II).
Using small cam lock (NN) to tighten the drawer front (S),
dawer left (N) and drawer right (O).
Hardware Used
II
5/32" x 15 mm Bolt
Handle
MM
Small Cam Lock
NN
14. Insert the drawer into the assembly by pressing down
the release levers on the slide runners and sliding the draw-
er into the tracks of slides.
15. Locate and mark wooden studs where the unit is to be
installed. Drill a 1/8" pilot hole on the wooden stud
approximately 3" below the height of unit top. Attach one
bracket (a) securely with screw (c) into the pilot hole on
the wall. Attach the other bracket (a) with screw (d) to the
back edge of unit top in line with the bracket (a) on the wall.
Adjust floor levelers to level the unit against the wall where
desired. Put the male end of the steel cable (b) through
each bracket (a). Securely connect both ends together by
turning the female connector clockwise.
Hardware Used
Tipping Restraint Hardware
LL
13
x4
x2
x8
14
15
x1
10
II
NN
MM
O
X2
Wooden Stud
Wall
b
a
S
N
b
d
a
c
Publicidad
