EGO SNT2120AP Manual Del Operador página 17

INSTALLING THE CHUTE
1. Use the supplied hex wrench to
loosen and remove the two sets of
bolts and washers in the chute base
(Fig. 6).
2. Align the grooves of the chute with
the slot on the chute base, and then
push the chute in place (Fig. 7).
3. Use the hex wrench to lock the
chute in place with the two sets of
bolts and washers (Fig. 8).
WARNING:
rotation handle located at the operator's
position, make sure that the chute rotates
properly with discharge opening never
crossing operator controls.
WARNING:
blower without the complete discharge
chute in place.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
Using the chute-
Never operate the snow
6
7
Groove of the Chute
Slot on
the Chute
Base
8
Chute Base
17