EGO SNT2120AP Manual Del Operador página 29

6. Insert the 5 bolts into the mounting
holes from the inside, shiny surface
of the scraper bar (Fig. 23a). Place
the spring washers and nuts on the
bolts (from the outside of the deck)
and securely fasten the scraper bar
to the deck (Fig. 23b).
REPLACING THE RUBBER
PADDLES & RUBBER AUGERS
(Fig. 24)
If the rubber paddles and rubber augers
become worn, excessively cracked,
frayed, or otherwise damaged, replace
them.
WARNING:
unit and remove the battery pack(s) before
performing any maintenance task on your
snow blower.
To replace the rubber paddles:
(Fig. 24a)
Required tools (not included):
◾
Flat head screwdriver
◾
13/32" (10 mm) open-end wrench
1. Wear gloves. Manually rotate the
steel auger to the appropriate
position for easy rubber paddle
disassembly.
2. Remove all securing bolts and nuts
to take the rubber paddles out.
3. Replace them with the new rubber
paddles, and securely tighten them.
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
Make sure to turn off the
23a
Scraper Bar
23b
Bolt
Scraper bar
24
Rubber Auger Rubber Paddle
24a
2 sets of bolts and nuts on
each paddle (total of 4 sets)
Nut
Spring Washer
Bolt
Spring washer
Deck
Nut
29