Publicidad
4.0 ADJUST AND FIT (Continued)
4.3
TIGHTEN BRACE: Move pull-tabs
4.4
STERNAL BAR: Open sternal bar clip
Sternal plate
when seated.
M
Sternal bar
Note: Only bend Sternal Bar above toothed area.
5.0 Modifications
The Back Panel, Anterior Panel
modified (2) to adjust lordosis, add scapula reliefs or create flares. The steel Sternal Bar
anatomical contours and the wings can be attached to the Velcro
accommodate various waist to hip ratios.
CAUTION: Do not trim top center tabs (3) on anterior panel.
5.1
ANTERIOR PANEL:
D
K
is 1 to 2" (25-50cm) below Sternal Notch when standing and 1/2" (23cm) below
can be bent to achieve proper fit with bending irons or over the edge of a table.
A
(shown), Lateral Panels and Wing Shells can be trimmed with scissors (1) and heat
anteriorly and re-attach.
L
to adjust height, then close clip to lock.
4.3
Connectors at up to 5 degree angles up or down to
®
4
REMOVING OR REPLACING STERNAL BAR
(with available Short Bar option)
• Remove anterior panel
from wing.
• Release sternal bar clip
and lower bar.
• Remove retainer clip (A)
by pushing through bar
while bending bar away
from panel.
• Pull bar
from bar slot.
• Replace bar, or (optional
Short Bar) into bar slot
and replace retainer
clip (A).
M
can be bent to match
L
M
up to remove
Note:
Clip (A) must be
replaced on the
panel side of bar.
Publicidad
