Publicidad
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
• Temperature setting of freezing chamber
Click temperature adjusting button of the freezing chamber
temperature will blink . Then click the button
you will hear one beep. Setting scope is between -12°C and -22°C. Every time you click
the button, the temperature will be changed 1°C. After adjusting, the digital tube will keep
blinking for 5 seconds. New temperature setting will take effect after locking the control
panel.
Recommended setting: Refrigerated chamber 4 °C, freezing chamber - 18 °C.
• Storage upon power failure
In case of power failure, the instant working state will be locked and maintained till re-
electrification.
• Opening warning and alarm control
when open the refrigerator doors, the opening music will play. If the door is not closed in
two minutes, the buzzer will sound once every minute until the door is closed. Press anyone
button to stop the buzzer alarm.
• Error code
The following warnings appearing on the display indicate corresponding faults of the
refrigerator. Though the refrigerator may still have cold storage function with the following
faults, the user shall contact a maintenance specialist for maintenance, so as to ensure
optimized operation of the appliance.
Error Code
E1
Temperature sensor failure of refrigerating chamber
E2
Temperature sensor failure of freezing chamber
E3
Freezing defrost sensor detection circuit error
E5
Communication error
E6
Ambient temperature sensor error
E7
Ambient temperature sensor error
14
, freezer compartment
again to set the temperature, and
Fault Description
EN
C
Useful information
Maintenance and care of the refrigerator
Overall cleaning
• Dusts behind the refrigerator and on the ground shall
be timely cleaned to improve the cooling effect and energy
saving.
• Check the door gasket regularly to make sure there are
no debris. Clean the door gasket with a soft cloth dampened
with soapy water or diluted detergent.
• The interior of the refrigerator should be cleaned regularly
to avoid odor.
• Please turn off the power before cleaning interior, remove
all foods, drinks, shelves, drawers, etc.
• Use a soft cloth or sponge to clean the inside of the
refrigerator, with two tablespoons of baking soda and a quart
of warm water. Then rinse with water and wipe clean. After
cleaning, open the door and let it dry naturally before turning
on the power.
• For areas that are difficult to clean in the refrigerator (such
as narrow sandwiches, gaps or corners), it is recommended
to wipe them regularly with a soft rag, soft brush, etc. and
when necessary, combined with some auxiliary tools (such
as thin sticks) to ensure no contaminants or bacterials
accumulation in these areas.
15
EN
Publicidad
