Placement Tool; Electrical Connection - stayer GAV2800 Manual De Instrucciones

This manual is consistent with the date of manufacture
of your machine, you will find information on the
technical data of the machine acquired manual check
for updates of our machines on the website:
www.grupostayer.com
1_MACHINE-SPECIFIC SAFETY
WARNINGS
The generator is designed to give safe and
dependable service if operated according to
instructions.
Read and understand the Owner's Manual before
operating the generator. Failure to do so could result
in personal injury or equipment damage.
Exhaust gas contains
monoxide. Never run the generator in an enclosed
area. Be sure to provide adequate ventilation.
The muffler becomes very hot during operation
and remains hot for a while after stopping the
engine. Be careful not to touch the muffler while it is
hot. Let the engine cool before storing the generator
indoors. To prevent scalding, pay attention to the
warning marks.
Gasoline is extremely flammable and explosive
under certain conditions. Refuel in a well ventilated
area with the engine stopped.
Keep away from cigarette, smoke and sparks when
refuelling the generator. Always refuel in a well
ventilated location.
Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over the
power tool.
Wipe up spilled gasoline at once.
Connections for standby power to a building's
electrical system must be made by a qualified
electrician and must comply with all applicable
laws and electrical codes. Improper connections can
allow electrical current from the generator to back feed
into the utility lines. Such back feed may electrocute
utility company workers or others who contact the
lines during a power outage, and when utility power is
restored, the generator may explode, burn, or cause
fires in the building's electrical system.
Always make a pre-operation inspection before
you start the engine. You may prevent an accident or
equipment damage.
Place the generator at least 1m (3ft) away from
buildings or other equipment during operation.
Operate the generator on a level surface. If the
generator is tiled, fuel spillage may result.
Know how to stop the generator quickly and
understand operation of all the controls. Never
permit anyone to operate the generator without proper
instructions.
Keep children and pets away from the generator
when it is in operation.
poisonous carbon
- 19
Keep away from rotating parts while the generator
is running.
The generator is a potential source of electrical
shocks when misused; do not operate with wet
hands.
Do not operate the generator in rain or snow and
do not let it get wet.
To prevent electrical shock from faulty appliances,
the generator should be grounded. Connect an
electric conductor (cable) of at least 1.5mm² between
the generator's ground terminal and an external
ground source.
Limit operation requiring maximum power to 30
minutes. For continuous operation, do not exceed
the rated power. In either case, the total wattage of all
appliances connected must be considered.
Do not exceed the current limit specified for any
one receptacle.
Do not modify or use the generator for other
purpose than it is intended for. Also observe the
following when using the generator:
- Do not connect generators in parallel.
- Do not connect an extension to exhaust pipe.
- When an extension cable is required, be sure to use
a rubber sheathed flexible cable.
- Limit length of extension cables: 60m for cables of
1.5mm and 100m for cables of 2.5mm
2
- Keep the generator away from other electric cables
or wires such as distribution network.
- The DC receptacle can be used while the AC power
is in use. If you use both at the same time, be sure not
to exceed the total power for AC and DC.
- Most appliance motors require more than their rated
wattage for start-up.
2_INSTRUCTIONS FOR USE

2.1 PLACEMENT TOOL

For your own safety, read this manual
and the general safety instructions
carefully before using the appliance.
Your power tool should only be given to
other users together with these instructions.
Be sure to check the generator on a level
surface with the engine stopped.

2.2 ELECTRICAL CONNECTION

AC applications
Start the engine and make sure that the output
indicator 9 shows 230 V.
Confirm that the appliance to be used is switched off,
and plug in the appliance.
-
es
it
gb
fr
p
.
2