Descargar Imprimir esta página

yeep.me 80n Manual De Instrucciones página 14

Ocultar thumbs Ver también para 80n:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 43
3.6. CHARGING AND BATTERY INDICATOR
EN
Charge the battery before first use. To do so, charge the device using the charger
supplied.
Important: Only charge the device with the original charger supplied with the device
by the manufacturer. In case of doubt, loss or malfunction, avoid charging the device
with another charger. It is advised you obtain a new charger from your dealer. You will
find the email address to contact customer support on the last page of the warranty
manual.
BATTERY SWITCH BUTTON :
The device is equipped with a battery switch button located next to the charging port
that serves two purposes:
1. Preserve the battery when the product is switched off.
2. Act as a second safety device in case of an untimely start using the ON/OFF button
on the handlebar.
CAUTION: The battery switch must be activated again in order to restart the device.
Battery switch button (long-term storage):
CAUTION: The battery will drain even when the product is switched off. This button
reduces the power consumption when the product is switched off to preserve the
battery for longer. However, it is important to recharge your device regularly as
described in this manual. In either position, this button does not prevent the product
from charging. It must be in the ON position for the device to work. It also serves as
an additional safety device against accidental start-ups.
NOTE: We recommend that you use the battery switch button if you are not going to
use the device for an extended period of time (more than 7 days). If the battery is not
recharged monthly or switched off using the battery switch, the battery may go into
deep sleep and be damaged. The damage and repairs this may cause are not covered
by the compliance warranty.
WARNING: The device must be unfolded and on its stand for charging to avoid dam-
aging the charging plug.
1. Remove the charging port cover and ensure there is no water or any other liquid
inside the charging connector, and that it is free of any objects that could cause
a short circuit or prevent the plug from being properly and safely plugged in. Then
connect the end of the charging cable to the charging port (7). BEFORE connecting
14

Publicidad

loading