Adjusting The Harness - Zy Safe izzygo L18 Manual De Instrucciones

N. ISOFIX/EASYFIX connector release button (x2)
O.
Tilt hatch
Installing the car seat with the harness
Group 1, 9 to 18 kg (approx. 9 months to 4 years)
WARNING
This is an ISOFIX SAFETY RESTRAINT DEVICE FOR CHILDREN. It is compliant with Regulation 44/04
•
for use in a vehicle fitted with an ISOFIX anchoring system.
It may be used in vehicles fitted with seats approved as universal ISOFIX positions (refer to your car
•
manual), according to the category and size of the child safety restraint.
• The mass group and the ISOFIX size class for which this product is suitable are: B1 / 9-18 kg.
If in doubt, please contact the car seat manufacturer or the retailer.
Assembling the booster seat
(2) (3)

Adjusting the harness

Make sure that the harness of your car seat is adjusted to the height of your child before installing it
in your vehicle. The shoulder harnesses can be adjusted to 3 different heights and must pass through
the holes closest to your child's shoulders. If your child's shoulders are between two levels always
use the higher of the two. To adjust the height of the harnesses, remove the upper section of one of
the straps by pivoting the metal anchor located behind the headrest (4), and then pulling the end of
the strap through the slots of the shell and the cover (5). Feed the end of the harness strap through
the same slots at the desired height, both in the cover and the shell
backrest (7). Make sure that the metal anchor is correctly positioned and that the end of the strap is
not twisted. Repeat the procedure with the second strap.
Installing the car seat and placing the child in the vehicle
This car seat must only be fitted on the rear seat of a vehicle equipped with ISOFIX fastenings
and a Top Tether anchor (universal ISOFIX). Please refer to your car manual.
WARNING! Your ISOFIX Group 1 car seat MUST be fitted using the Top Tether strap provided! Your
child's safety cannot be guaranteed if you install your ISOFIX Group 1 car seat without the Top Tether
strap.
Put the headrest of the car seat at its lowest position. Fold the Top Tether strap over the back of the
car seat so that it does not get trapped during installation (8). Extend the ISOFIX/EASYFIX connectors
from the car seat as far as possible (9).
Position the car seat on the rear seat of the vehicle bring the ISOFIX/EASYFIX connectors in line with
the seat's ISOFIX anchor points (10). Click the ISOFIX/EASYFIX connectors into the anchor points;
the indicators on each connector should turn from red to green (11). Release the safety catch of the
ISOFIX / EASYFIX system by pulling the red handle of the base and then simultaneously push the
car seat by exerting a uniform pressure on the seat backrest until the rear of the car seat is pressed
against the vehicle seat (12).
Bring the Top Tether strap over the vehicle seat and attach the clasp to the vehicle's Top Tether anchor
point (13).
Depending on the make of your car, the additional Top Tether anchor point may be located:
22
GB - User guide
(6)
and reattach it behind the