Important; Removing The Car Seat - Zy Safe izzygo L18 Manual De Instrucciones

Installing the car seat and placing the child in the vehicle
Your car seat is fitted with an adjustable headrest that has been designed to support your child
throughout growth by providing maximum lateral protection.
IMPORTANT: When using the car seat without the harness, it must only be installed with a 3-point
safety belt (23). Never install the car seat within 2-point safety belt (24)!
Raise the adjustable headrest to its highest position. Extend the ISOFIX/EASYFIX connectors from
the car seat as far as possible (9). Position the car seat on the rear seat of the vehicle bringing the
ISOFIX connectors in line with the seat's ISOFIX anchor points (25). Click the ISOFIX connectors into
the anchor points; the indicators on each connector should turn from red to green (26). Ensure that
the vehicle seat belt buckle remains accessible and that it has not been placed under the car seat.
Release the safety catch of the ISOFIX/EASYFIX system by pulling the red handle attached to the base
and gently pushing the car seat (27). With the safety catch released, push the car seat by exerting
equal pressure on both sides until the rear of the car seat is pressed firmly against the vehicle seat and
then feed the diagonal strap of the belt through the headrest guide (28).
Sit your child in the car seat. Make sure that the child's back is fully in contact with the back of the
car seat. Pull and fasten the vehicle seat belt. Pass the diagonal strap of the belt under the armrest
opposite the belt guide used. The waist strap of the belt passes under both armrests (29). Lower the
adjustable headrest and adjust it to the height of your child (30). It should be positioned so that
it surrounds your child's head, providing maximum lateral protection, whilst guiding the diagonal
(31) (32). Tighten the
belt over the child's shoulder so that there is no contact with the child's neck
vehicle seat belt.
Ensure that the belt is properly tightened, that it is not twisted and that it is not at the level of your
child's neck.
To remove your child from the car seat, simply unbuckle the seatbelt and place it at the side of the car
seat. The belt will remain suspended from the headrest belt guide.

Removing the car seat

Step 1 (Group 1): Loosen the Top Tether strap (33), then release the strap from its anchor point and
bring it towards you (34).
Step 1 (Group 2/3): Remove the diagonal strap of the seatbelt from the belt guide of the adjustable
headrest (35).
Step 2 (all groups): Pull the car seat using the red handle on the ISOFIX base (36). On either side of
the seat, release the ISOFIX connectors from their anchor points by pulling the release buttons to-
wards you. The indicators will turn from green to red (37) (38). The car seat can now be removed (39).
Returning to the original configuration of the car seat
Follow the instructions below if you wish to return to the harness configuration.
Re-install the crotch strap, making sure that the metal keeper is correctly in place under the seat (40).
Via the front of the backrest, between the cover and the shell, grasp and twist the metal anchor of
one of the two other sections of the harness, simultaneously pulling the section through from the
back (41). Re-install it via the front of the backrest at the desired height (42). Make sure the metal
anchor of the harness section is correctly in place behind the backrest (43). Repeat the procedure
with the second section of the harness. Make sure the harnesses are not twisted.
24
GB - User guide