Publicidad
Idiomas disponibles
Idiomas disponibles
•
Behind the rear seat of the vehicle.
•
On the floor to the rear of the vehicle.
•
On the ceiling to the rear of the vehicle.
Please refer to your car user manual to locate the additional Top Tether anchor point. Never attach the
Top Tether to a point that is not recommended by the vehicle manufacturer. Never alter the vehicle
yourself in order to try and fasten the Top Tether (for example by piercing, screwing or attaching an
anchor point yourself ).
Push the car seat against the back of the vehicle seat and pull on the loose end of the Top Tether strap.
When the belt is fully tightened, the indicator on the Top Tether strap will turn from red to green (14).
Open the buckle of the harness by pressing on the red button in the centre of the buckle (15). Sit your
child in the car seat. To close the harness, join together both ends of the shoulder straps and slide
them into the buckle harness. You should hear it click (16).
Tightening the harness: Pull on the adjusting straps located on the harness. You do not need to
•
press on the adjuster buttons (17).
should not be able to slide more than two fingers between the shoulder strap and the child's chest.
Loosening the harness: Press on the adjuster buttons located on the upper part of the harness,
•
while pulling at the same time on the lower harness sections (18). Press on the red harness buckle
button to free your child completely.
Some ISOFIX car seat models are fitted with a buckle that sets off an audible alarm (available as an
option). This alarm warns the parents if the child opens the buckle at an inopportune moment dur-
ing the journey.
IMPORTANT: A properly adjusted harness is essential to ensure maximum protection for your child.
There should not be more than two fingers width between the harness and the child.
Installing the car seat without the harness
Group 2-3, 15 to 36kg (approx. 3 to 12 years)
WARNING
This is a 'SEMI-UNIVERSAL' SAFETY RESTRAINT DEVICE FOR CHILDREN. It is compliant with Regu-
•
lation 44/04 and may only be used in vehicles specified in the adjoining list of approved vehicles.
•
It can only be fitted on vehicles with 3-point safety belts, whether fixed or inertia-reel, compliant
with UN/ECE N°16 or an equivalent standard.
If in doubt, please contact the car seat manufacturer or the retailer.
Ensure that the harness and the Top Tether strap of your car seat are removed before begin-
ning installation in your vehicle.
Removing the harness and the Top Tether strap
Remove the Top Tether strap
to undo the harness if necessary. Repeat steps
one section of the harness and feed it to the back (20), attach the metal anchor of the harness to the
back of the seat (21). The metal anchor must be positioned between the shell and the car seat cover.
Repeat the procedure on the second section of the harness. Check that the harness connectors have
also been passed behind the back rest. Remove the crotch strap by twisting the metal keeper and by
passing it through the slots in the base and the cover (22).
IMPORTANT: A poorly fitting harness can be dangerous. You
(19)
and store it carefully for future use. Press on the red harness button
(4)
and
(5)
on each upper section of the harness. Take
User guide - GB
23
Publicidad
