Oregon CS300 Manual De Instrucciones página 37

OREGON® Cordless Tool System
CHAIN SAW MODEL CS300
SYMPTOM
Heavy use has
overheated the motor
Steady alarm
beeping when
trigger pulled
Chain brake is engaged
Battery pack over/under
temperature protection
is activated
Dirty or damaged
contacts on battery
Battery pack does
pack or charger
not charge
Battery pack is at the
end of its life
Charger faulty
Dull chain
Worn chain
Dry chain
Low cut time per
Over tensioned chain
battery charge
Improper cutting
technique
Debris in side cover
Battery pack not fully
charged
Charger short circuit,
charger over current,
Blinking orange
over voltage limit, open
light on charge
circuit on battery pack,
state indicator
or charge/pre-charge
time out error
AA 1214 - F/N 573259
POSSIBLE CAUSE
Let the saw cool down and then resume cutting .
Before starting, make sure the hand guard is in its
most rearward position (chain brake disengaged) .
For correct hand guard position, see "Starting the
Saw" in this manual .
This may occur when the saw is run continuously or
exposed to high ambient temperatures . Allow the
battery pack to reach the acceptable temperature
before charging . See "Battery Pack and Charger" in
this manual .
Inspect the contacts on the both the battery pack
and charger . If necessary, clean according to the
instructions in this manual . Reinsert battery pack
into the charger, making sure it is fully seated .
All batteries have a limited life . If the battery pack
is more than two years old or has been recharged
frequently, it may be time to replace it . Replace
only with the battery pack specified for this chain
saw .
Have the function checked at an approved service
location .
See "Sharpening with PowerSharp®" in this manual .
Replace the chain . See "Replacing a Worn Saw
Chain and Sharpening Stone" in this manual .
Check the oil level . Refill oil reservoir if necessary .
See "Filling the Bar and Chain Oil Reservoir" in this
manual .
See "Tensioning the Saw Chain" in this manual .
Follow guidelines in "Cutting" in this manual .
Remove battery pack, then remove side cover and
clean out debris .
Recharge . See "Battery Pack and Charger" in this
manual .
1 . Make sure the charger cord is connected to both
2 . Make sure the charger is receiving the correct
3 . Try charging another battery pack designed for
If this does not correct the problem, have the
function checked at an approved service location .
TROUBLESHOOTING
RECOMMENDED ACTIONS
the charger and the electrical outlet .
voltage .
this charger .
35