Publicidad
Idiomas disponibles
Idiomas disponibles
2. SAFETY INSTRUCTIONS
damage to property.
2. Switch off and disconnect from the power supply if there is any
malfunction. Have the product checked by a qualified specialist and
repaired, if necessary, before you put it into operation again.
Maintenance
If the supply cable is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a
hazard.
If the carbon brushes need to be replaced, have this done by a qualified
repair person (always replace the two brushes at the same time).
To ensure long and reliable service, carry out the following maintenance
regularly. Servicing and cleaning work on the pruner and the removal of
the guards may only be carried out after the motor has been switched off
and the plug disconnected from the power supply.
1. Regularly check for obvious defects such as loose, dislodged or
damaged chain and guide bar, loose fixings and worn or damaged
components.
2. Check that covers and guards are undamaged and correctly fitted. Carry
out necessary maintenance
or repairs before using the pruner.
3. If the saw chain should happen to fail despite the care taken in
manufacturing and testing, repair should be carried out by an
authorized specialist.
4. Do not clean the pruner while it is running.
5. Ensure that all the fastening elements (screws, nuts, etc.) are tight at
all times so that you can safely work with the pruner.
6. Check the pruner frequently for signs of wear. Replace worn or
damaged parts.
7. Store your pruner in a dry place. To ensure a long service life all screw
EN
264
Publicidad
