Thermomix TM6 Manual De Instrucciones página 12

12
Damage to the
appliance as a result of
an incorrect power
connection.
Risk of damage from
improper use of the
Varoma®.
Damage to the
appliance as a result of
incorrect cleaning or
failure to observe
instructions on long-
time cooking.
Corrosion inside the
appliance.
Material damage as a
result of the incorrect
assembly of the mixing
knife.
Material damage from
improper use.
For Your Safety
If the base unit is connected to an inadequate power supply, it will
get damaged.
• Only operate Thermomix® TM6 with the alternating current voltage and
mains frequency stated on the plug label.
Thermomix® TM6 can get damaged if there is too little water in the
mixing bowl.
• Make sure that there is enough water in the mixing bowl. Approx. 250 ml
of water will evaporate in 15 minutes in Thermomix® TM6.
• Top up the water if necessary, especially if you have subsequently
increased the steaming time.
If the mixing bowl and mixing knife are in contact with water, other
liquids or food residues for a long time, they could get damaged.
• Always clean the components directly after use.
• Do not leave the mixing knife in water for a long time as this may damage
the gasket system of the knife bearing.
• Because of variations in water quality, it is also possible for rust to form in
the mixing bowl when cooking food over a long period of time (slow
cooking, sous-vide or fermenting). Therefore please follow the instructions
on adding special ingredients (e.g. citric acid) to the cooking water.
Ensure that the mixing bowl and especially the contact pins
underneath are thoroughly dried after cleaning. If you use the mixing
bowl when it is still wet, rust could form inside the base unit.
• Allow the mixing bowl to dry fully before inserting it into the base unit.
If the mixing knife is not correctly inserted and locked into place or
the sealing ring is damaged, moisture can get inside the appliance
and damage the base unit.
• Ensure that the sealing ring of the mixing knife is fitted to the knife
bearing.
• Ensure that the sealing ring on the mixing knife shows no signs of
damage.
• Ensure that the mixing knife is correctly inserted and locked into place
before filling the mixing bowl.
• If liquid leaks or spills into the housing of the base unit, unplug the
appliance and contact the repair service.
If the butterfly whisk comes into contact with the mixing knife or
other accessories when the appliance is running, it could crack or
break.
• Ensure that the butterfly whisk is correctly attached to the mixing knife
before setting the speed.
• Do not exceed speed 4 when the butterfly whisk is fitted.
• Do not use the spatula when the butterfly whisk is fitted.
• Do not add any ingredients that could damage or block the butterfly
whisk.
Thermomix®