Troubleshooting - Thermomix TM6 Manual De Instrucciones

Thermomix®
Error:
Liquid has seeped into the area below
the mixing bowl.
Thermomix® TM6 cannot be switched
on.
The mixing bowl will not go into
Thermomix® TM6 base unit.
Thermomix® TM6 does not heat.
8

TROUBLESHOOTING

HAZARD
Risk of an electric shock if the base unit or
power cord are damaged.
If the base unit or power cord are damaged, you could
get an electric shock.
• Regularly inspect the base unit, power cord and accessories
for possible damage.
• Ensure that the power cord does not touch hot surfaces or
external heat sources.
• Never use your Thermomix® TM6 if the power cord is
damaged.
• Do not use the base unit if it is dropped or damaged in any
way.
• In the event of damage to the base unit or the power cord,
return your Thermomix® TM6 to the Vorwerk repair service
for examination, repair or electrical or mechanical
adjustment.
• If the power cord on the base unit has been damaged, it
must be replaced by the manufacturer, its repair service or a
similarly qualified person to avoid hazards.
• Never attempt to repair the base unit yourself.
• Never put your fingers into the openings that are intended
for the contact pins on the base of the mixing bowl and do
not insert any objects into these openings.
Possible cause and rectification:
– Unplug the appliance immediately.
– Use a towel to dry excess liquid from underneath the mixing bowl.
– To prevent liquid from getting into delicate components inside the
base unit, do not move it or turn it over.
– Do not attempt to disassemble the appliance. It does not contain
any parts that you can service yourself.
– If you cannot be certain that no liquid has entered the base unit, do
not switch on your Thermomix® TM6. Instead, contact
Care [} 25].
The base unit may not be connected correctly.
– Check if the power cord has been properly plugged in.
The mixing bowl may not be correctly assembled.
– Check whether the mixing bowl base is locked into place correctly.
The heating time may not have been set correctly.
– Check whether you set a time using the time dial.
The temperature may not have been selected.
– Check if you set the temperature.
23
en
Customer