Fx Settings - Tascam Sonicview 16 Manual Del Usuario

Idiomas disponibles

SEL keys

Press a channel section SEL key (5) or the master section SEL

key (y) to open the MODULE Screen for the selected channel.

Tap the desired screen selection button at the top of the

MODULE screen, and use the touchscreen (1) and LCD knobs

(2) to set various parameters.

Faders

The 16 channel faders of Sonicview 16 and the 24 channel

faders of the Sonicview 24 show the SEND levels to the

following buses.

o MAIN L/R bus when the SENDS ON FADER key (k) is off

(unlit)

o Selected MIX SEND/FX SEND bus when the SENDS ON FADER

key (k) is on (lit)

Use the Use LAYER KEYS 1–7 (p) to move between the 7 fader

layers, and set their levels.

The MASTER fader (a) controls the master SEND level of the

selected bus.

Copy/Paste

Tap the

button at the top right of the MODULE Screen to

open the MODULE pull-down menu.

Parameters can be copied and pasted using the MODULE menu.

Parameters that can be copied and pasted differ according to

the open MODULE screen.

To copy or paste all the parameters of the selected channel

module, execute Copy MODULE or Paste MODULE in this

MODULE menu.

Output connector assignments (output

routing)

To check and change output connector routing settings, tap

the Output Area at the top of the Home Screen for a MIX 1–22

module (a area in "Setting various parameters on the Home

Screen" on page 13) to open the MODULE (OUTPUT) Screen.

To check and change MAIN L/R output connector routing

settings, press the MASTER section SEL key (y) to open the

MAIN L/R master MODULE Screen. Then, tap the OUTPUT screen

selection button at the top of the screen to open the MODULE

(OUTPUT) screen.

TASCAM Sonicview 16/Sonicview 24

FX settings

o Tap the FX area (a area in "Setting various parameters on the

Home Screen" on page 13) at the top of the Home Screen

of the FX RTN 1-4 module to show the selection frame.

Then, use the LCD knobs (2) to adjust the parameters being

shown.

o When the selection frame is shown on the FX area (a), tap

it to open the MODULE (FX) screen for the FX RTN module.

On this screen, use the touchscreen (1) and LCD knobs (2)

to make FX parameter settings and change the FX TYPE.

The FX Library Screen can also be opened from this screen.

In addition, on the FX LIBRARY Screen opened using the

LIBRARY button on this screen, preset data can be recalled

and current settings can be stored.