Commissioning And Troubleshooting; Product Specifications - EcoFlow 100 W Rigid Solar Panel Manual De Instrucciones

6. Commissioning and Troubleshooting

EcoFlow recommends that all commissioning and maintenance of the solar module system be carried out by
qualified PV technicians!
Test connected modules before connecting them to the system; always test all electrical and electronic components
of the system before commissioning the system, and always follow the instructions supplied together with each
part and piece of equipment.
To test the electrical performance of the module, the module is generally exposed to sunlight and must not be
connected to a load. Pay attention to your personal safety when taking these measurements.
Should abnormal power generation occur, troubleshoot the issue by following the steps below:
• Check all wiring to ensure that there are no open circuits or poor connections.
• Check the open circuit voltage of each module.
• Check the open circuit voltage with the module completely covered with opaque material; then remove the
opaque material and measure the open circuit voltage at its terminals and compare.
If the voltage between the terminals differs by more than 5% from the nominal value at an irradiance of ≥700 W/m
2
(65.0 W/ft ), this indicates a poor electrical connection.

7. Product Specifications

100W Rigid Solar Panel
Rated Power: 100 W (+/-5 W)
Open Circuit Voltage: 20.3 V
Short Circuit Current: 6.3 A
Maximum Operating Voltage: 17.1 V
Maximum Operating Current: 5.9 A
Temperature Coefficient of Rated Power: -0.39%/°C
Temperature Coefficient of Open Circuit Voltage:
-0.33%/°C
Temperature Coefficient of Short Circuit Current:
0.06%/°C
Maximum System Voltage: 600 VDC (UL)
Maximum Fuse Current: 15 A
General
Solar Panel Weight: Approx. 6.2 kg (13.7 lbs)
Dimensions: 98*58.6*3 cm (38.6*23.1*1.2 in)
Testing and Certification
*Standard Test Conditions: 1,000 W/m
9
IP68
2 2
(92.9 W/ft ), AM1.5, 25°C
2