Fulgor Milano FWC 8200 U TC Instrucciones De Instalacion Y Uso página 35

mod. 82cm
1. Put the cabinet on open operation place, the door
opened to the maximum angle.
2. Use small knife(2) to take off the decorative nail (1) on
opposite side (Drawing 1);
3. Use the inner six angle screwdriver (Tool 5) to disassemble
the screws(4) of drop-proof device (3), then remove the
drop-proof device .(Drawing 1)
4. Hold the door, use six angle screwdriver (Tool 5) to screw
out the door shaft core(6) from the two ends of the top of
the door. Take out the door and set aside. (Drawing 2)
1. Decorative nail
2. Knife
Drop-proof device
3.
4. M5 six angle
5. M5 six angle screwdriver
6. Door spindle core
7. Upper door hinge
Lower door hinge
8.
5. Discharge the upper and lower door hinge(7)(8) by M5
inner six angle screwdriver (Tool 5) , then to assemble
the door hinge on the opposite side. (Drawing 3 and 4 )
6. Rotate the door 180 degrees, then Install the door on the
right side of the cabinet. (Drawing 5)
7. Finally, install the decorative nail and drop-proof device
at the opposite side. (Drawing 6)
EN
15