Edenwood FIRE LIGHT Instrucciones De Uso página 29

B
Product usage
NOTE:
• If the speaker's Bluetooth name does not appear on your Bluetooth device,
move the two devices closer together. If that doesn't work, turn the devices
off and back on again before restarting the pairing process.
• When pairing the devices, make sure they are less than 10 metres apart and
there are no physical obstructions between them.
• Once two devices have been paired, these devices should remember the
connection. To connect to a previously paired device, press and hold the
button whilst bLUE is flashing.
Connecting two speakers (TWS)
You can connect two FIRE LIGHT speakers to an external audio device. This function only
works in Bluetooth mode.
1. Make sure that both speakers are not connected to any other Bluetooth devices.
2. Place the speakers within 10 metres (with no obstructions) of each other.
3. Turn on both speakers and the ON sound will play, and bLUE will flash on the display.
4. In Bluetooth mode, press and hold the
master speaker). A sound will play on both speakers to confirm they are connected in
TWS mode.
1. Connect the external Bluetooth device through its Bluetooth settings to the speakers.
Choose the pairing name of the master speaker. When connected, bLUE will stop flashing
and a sound will play to confirm that the devices have paired.
2. Press and hold the
will play to confirm the units are disconnected.
NOTE:
• You can only connect the two speakers when you are in Bluetooth mode. Once
the two speakers have been connected in TWS mode, if they are turned off and
then later turned on again, they will automatically reconnect with each other.
• You can only connect a FIRE LIGHT speaker with another FIRE LIGHT speaker.
You cannot pair the FIRE LIGHT speaker with other models or brands of
speakers that have TWS capability.
• If you want to make a TWS connection with a different speaker, remove previous
connections before attempting to connect with the new speaker.
• If you cannot successfully connect two speakers, turn off both speakers and
start the connection process again.
Operation
WARNING! Before plugging in and switching on the speaker, make sure that all
the controls are turned off or set to the minimum level.
button on one of the speakers (this will be the
button on either speaker to stop using the TWS mode. A sound
27 EN