Publicidad
Idiomas disponibles
Idiomas disponibles
Parts are located throughout the shipping carton, including underneath the smoker. Inspect the unit, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the smoker
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Grills Customer Care for parts.
IMPORTANT: Using two people is necessary when assembling this unit.
Tools required for assembly: Phillips screwdriver. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.
1. INSTALLING THE WHEELS
Parts Required:
1
x
Barrel Body (#4)
2
x
Wheel (#17)
2
x
Wheel Axle Pin (#A)
2
x
Wheel Washer (#B)
2
x
Wheel Cotter Pin (#C)
Installation:
•
Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly.
•
Insert Wheel Axel Pin through the Wheel to the base of the Barrel Body
and into the hole, as shown. From below, add a Wheel Washer, then
secure using the Wheel Cotter Pin. Repeat same installation for the
other Wheel.
NOTE: Once installed, both wheels should spin freely.
4
ASSEMBLY PREPARATION
www.pitboss-grills.com
ASSEMBLY INSTRUCTIONS
1
4
17
B
A
C
B
C
17
A
C
Publicidad
