Assembly And Operation - KRESS KUB35.91 Manual De Instrucciones

The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Inserting and Removing Socket
OPERATON
Uncertainty K = m/s²
FIGURE
See Fig.
A1,A2
Forward And Reverse Rotation
Control
WARNING: Never Change
The Direction Of Rotation
When The Chuck Is Rotating,
Wait Until It Has Stopped!
Variable Speed Control
Operating the On/Off Switch
WARNING: Do not operate
for long periods at low
speed because excess heat
will be produced internally.
Using The LED Light
Before operation, the LED light
will be activated when the On/Off
switch is slightly depressed, and will
automatically turn off 20 seconds
after the On/Off switch is released.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 3
seconds and turn off, the system
will automatically cut off power
to the tool to extend battery life.
The tool will automatically stop
during operation if the tool and/or
battery are placed under one of the
following conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
• Overheated: Under the
condition above, if the tool does
not start, the Tool and Battery are
overheated. In this situation, let the
Tool and Battery cool before pulling
the Trigger Switch again.
• Low battery voltage: The
remaining Battery capacity is too
low and the tool will not operate. In
this situation, remove and recharge
the Battery.
WARNING:
To turn on the light, press the
On/Off switch and make sure the
Forward/Reverse Rotation Control
is on right/left position.
MEGO FORCE
High-power motor + High inertia hammer head, High
torque output
MEGA power control system, continuous High torque
See Fig.
B,C1,C2
See Fig. D
See Fig. E
9
EN
See Fig. E