Publicidad
Idiomas disponibles
Idiomas disponibles
▪
In the event of a power interruption, release the locking switch by pressing the
on/off switch. This will prevent the power tool from restarting unintentionally
(risk of injury).
▪
Do not use the power tool in a stand.
▪
When working with this machine wear ear protectors, goggles, dust
mask, protective gloves and protective boots.
During use, always hold the machine with both hands and maintain a
▪
safe standing position. Start up and run down the machine in the mixing
container only. Pay attention to the reaction moment of the machine.
For further safety instructions, please refer to the enclosure.
Before starting the machine check the correspondence between voltage and
frequency according to the data mentioned on the identification plate. Voltage
differences from + 6 % and – 10 % are allowed.
The stirrer is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section which is
too small could lead to an excessive power loss and to an overheating of motor
and cable.
Tool Change
Attention!
Before any work on the tool, disconnect the plug from the mains!
When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread. Keep threads and
front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Tool Protection
Wrong handling can cause damages on the tool. Therefore, the following
instructions should be observed:
Only use stirring rods which have a M 14 – external thread
(diameter 140 mm max.) and are recommended by the producer.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Electrical Connection
14
Publicidad
