Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
OPERATING INSTRUCTIONS
AC/DC VOLTAGE (LESS THAN 600V)
1. Insert RED test lead into VΩ jack
COM jack
, and rotate function selector switch
4
Voltage
or AC Voltage
display.
Black lead
2. Apply test leads to the circuit to be tested to measure voltage.
The meter will auto-range to display the measurement in the
most appropriate range.
NOTE: If "–" appears on the LCD, the test leads are being applied to
the circuit in reverse. Swap the position of the leads to correct this.
NOTE: When in a voltage setting and the test leads are open,
readings of order mV may appear on the display. This is noise and
is normal. By touching the test leads together to close the circuit
the meter will measure zero volts.
NOTE: To access mV range for V AC
must be used.
Manual Mode Sequence
First
Second
Press
Press
AC Range
0-600V
0-200V
DC Range
0-20V
0-2V
NOTE: When voltages in excess of 25V AC or 60V DC are measured,
the Hazardous Voltage Indicator
10
, and BLACK test lead into
5
to the DC
2
setting. Note "DC" or "AC" on the
Red lead
OR
the "RANGE" button
Third
Fourth
Fifth
Press
Press
Press
0-20V
0-2V
0-200mV
0-200mV
0-600V
0-200V
will appear on the display.
RESISTANCE MEASUREMENTS
1. Insert RED test lead into VΩ jack
jack
, and rotate function selector switch
4
setting. The resistance symbol will appear on the display.
2. Remove power from circuit.
3. Measure resistance by connecting test leads to circuit. The
meter will auto-range to display the measurement in the most
appropriate range.
Black lead
NOTE: When in a Resistance setting and the test leads are open
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
DO NOT attempt to measure resistance on a live circuit.
CONTINUITY
1. Insert RED test lead into VΩ jack
jack
, and rotate function selector switch
4
setting.
2. Remove power from circuit.
3. Test for continuity by connecting conductor or circuit with test
leads. If resistance is measured less than 10Ω, an audible signal
will sound and display will show a resistance value indicating
continuity. If circuit is open, display will show "OL".
7
Black lead
DO NOT attempt to measure continuity on a live circuit.
OPERATING INSTRUCTIONS
, and BLACK test lead into COM
5
2
Red lead
and BLACK test lead into COM
5
2
Red lead
to the Resistance
to the Continuity
11
Publicidad
