Cleaner Control Unit; Submerging The Cleaner - Polaris NEO EM27 Manual Del Propietário

Page 6
4.1

Cleaner Control Unit

Surface Control
System™ (SCS)
for wall cleaning
(rough to smooth
surfaces)
Cleaner Error
Indicator
Select Cleaning Surface
• Floor
• Floor and Walls
4.2

Submerging the Cleaner

1. Submerge the cleaner vertically (1) and hold it
under the surface, moving gently from side to
side (2) until the bubbles stop to remove any air
trapped inside.
2. When the bubbles stop, allow the cleaner to
sink to the bottom of the pool.
3. Verify the cleaner is sitting on the bottom
of the pool. Remove additional air if the cleaner
is still fl oating.
NOTE: The handle of the cleaner remains up whether the
cleaner is OFF or ON.
4. Spread the fl oating cable over the pool, making
sure there are no kinks or coils in the cable .
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the middle
of the pool length. Only place enough cable in the
water to reach the farthest point in the pool.
SURFACE CONTROL SYSTEM
1 2 3 4
ROUGH SMOOTH
Figure 4.
LEDs indicating
pump strength for
SCS
1
2
Submerge and Remove Trapped Air
Start/Stop
Cleaner