DJI AGRAS T40 Guia De Inicio Rapido página 11

Drag the map and tap
Add to add a point at the
crosshair position. Tap
to save.
After reconstruction, tap Plan Field and follow steps 3 to 6 in the following section to add points and perform
operations. Users can also tap
Planning Field and Performing Operation
In Operation View, tap
the mode button at the
top left and select Route
on the Agriculture panel.
Tap to use the field.
Only take off in open areas and set an appropriate Connection Routing and RTH Altitude according to the operating
environment.
An operation can be paused by moving the control stick slightly. The aircraft will hover and record the breakpoint.
After that, the aircraft can be controlled manually. Select the operation again to continue. The aircraft will return to the
breakpoint automatically and resume the operation. Pay attention to aircraft safety when returning to a breakpoint.
In Route Operation mode, the aircraft is able to circumvent obstacles, which is disabled by default and can be enabled
in the app. If the function is enabled and the aircraft detects obstacles, the aircraft will slow down and circumvent the
obstacles and return to the original flight path.
Users can set the action the aircraft will perform after the operation is completed in the app.
More Operation Modes and Functions
Refer to the user manual for more information about the A-B Route, Manual, Manual Plus, and Fruit Tree
operation modes, and on how to use functions such as Connection Routing, Operation Resumption, System
Data Protection, and Empty Tank.
Maintenance
Clean all parts of the aircraft and remote controller at the end of each day of spraying after the aircraft returns to
a normal temperature. DO NOT clean the aircraft immediately after operations are completed.
10
Tap and move the slider
to take off. The aircraft will
perform the mapping operation
along the route automatically.
to cancel the current selection and start a new mapping operation.
Tap on the bottom right,
tap in the middle of the
right screen, select Crosshair,
and select the type of point.
Set task and route
parameters respectively,
drag to adjust the flight
direction of the route, and
save.
Wait for the reconstruction
to be completed. The
reconstruction result will be
displayed on the original map.
Drag the map and tap Add to
add a point on the map. Tap
to save.
Tap , check the aircraft
status and task settings, and
move the slider to take off.
The aircraft will perform the
operation automatically.