Publicidad
Idiomas disponibles
Idiomas disponibles
8
11.2 Assembly instructions for electrical (suitable for RI822-RI824-RI826-RI828)
FIG.10a
(image for illustrative purpose only)
1. Remove the bolts prepared from the arm and from the column holes for the actuator fixing.
Fit the actuator in the correct position and fix it using the bolts previously removed.
(Fig.10a-10b)
2. Fix the support bracket of the control unit to the column with the provided screws, screwed
up the correct fitted holes. (Fig.11)
3. Fit the control unit on the bracket, letting it slide from top to bottom and blocking it with
the provided screws. (Fig.12a-12b)
4. Fit the battery into the control unit cavity.(Fig.13a-13b)
5. Connect the actuator connector to the central socket of the control unit and the remote
control to the right socket. (Fig.14). The electric kit is correctly mounted and the
stand-up lift is ready to use. (fig.15)
FIG.12a
FIG.13b
(image for illustrative purpose only)
Nota:
Before use, be careful to check that the emergency button is not pressed, and if
activated, release it to allow the switch on of the control unit.
FIG.10b
FIG.12b
FIG.14
FIG.11
FIG.13a
FIG.15
Publicidad
