Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Tighten the bolt securely after securing the handle brace. See
Figure 4.
5.
Locate the carriage bolt, bell washer and hand knob packed with
your tiller.
6.
Insert the carriage bolt through the welded bracket on the handle,
bell washer, handle brace and into the hand knob. See Figure 4.
7.
Select one of the three handle height positions (three notches in
the welded handle bracket) and tighten the hand knob to secure
the handle in the desired position. See Figure 4. Return to the
lower handle and tighten the hex bolt securely.
ATTACHINg THE DEPTH gAgE
1.
Disassemble the depth gage assembly. See Figure 5. Retain the
pin and clip for later reassembly.
2.
Remove the two screws from the tail bracket. See Figure 6.
3.
Insert the depth gage bracket into the frame and reinstall the
two screws removed earlier. Tighten the hex bolts securely. See
Figure 6.
4.
Insert the depth stake into the depth gage bracket assembly. See
Figure 7.
5.
Secure the pin with the clip removed earlier. The depth stake can
be placed at various positions. For setup purposes it is suggested
that the depth stake be assembled with the stake just above
or level with the ground surface. For further instructions on the
Depth Stake refer to the Operation Section of this manual.
ASSEMBLY
Hand Knob
Carriage Bolt
Bell washer
Handle Brace
Figure 4
Clevis
Pin
Cotter
Pin
tail Bracket
screws
Cotter
Pin
9
tail Bracket
Depth
stake
Figure 5
Figure 6
Clevis Pin
Figure 7
Publicidad
Solución de problemas
