Abus SmartX Manual De Instrucciones página 10

• It is imperative to keep the ABUS
keycard in a safe place even after
completing the setup! You need the
keycard for software updates, if you lose
your smartphone, and for proof of
ownership for matters related to
warranty claims and repair. Do not give
the card to third parties.
Initial start-up for remote control
You will need the ABUS SmartX app to
program the remote control.
• Remove the battery protective strips
• The SmartX lock must already be
programmed with the SmartX app
• On your smartphone, the app must be
open and Bluetooth® and location
services must be enabled
• There must be a Bluetooth® connection
between the smartphone and the lock
• In the app, select the function "Add
accessories" and follow the instructions
18
in the app
• After programming, the remote control
will be in "manual mode": the SmartX
lock can be operated by pressing the
button on the remote control.
Operating the remote control
1. Manual mode:
The remote control only transmits after
the button is pressed (transmits for
approx. 5 seconds). The LED will flash
green once to confirm
2. Switch mode (manual < > automatic)
Press and hold the button for about 5-15
seconds to switch modes. When you re-
lease the button, the LED will briefly flash
green: the mode has been changed.
If the button is held for longer than
15 seconds, the mode will not be
changed, as this could be caused by
an object in a backpack accidentally
pressing against the button, for
example.
LED signalling when mode has been chan-
ged: manual > automatic
flashes green 5 times
automatic > manual
lights up green for approx. 3 sec.
19