Restart Protection; Overload Protection - Bosch AXT 2200 HP Manual Del Usuario

EURO • Printed in Germany • BA F016L69647 • AXT 2200 HP / AXT 2500 HP • GB • OSW 05/99
AXT 2200/2500 HP - Buch Seite 12 Mittwoch, 14. Juni 2000 8:09 08
Undercarriage
Take the machine out of the packaging according
to fig. A.
Remove the wooden pieces (transport protection,
fig. B).
The wheels and stand must be mounted accord-
ing to figures C and D.
When transporting without the stand, always
use the transport safety piece.
Before use
Always use the correct supply voltage: The
power supply voltage must match the information
quoted on the tool identification plate. Tools with
a rating of 230 V can also be connected to a
220 V supply.
The circuit must at least be protected as follows:
AXT 2200 HP = 10 A,
AXT 2500 HP = 16 A.
When being operated with a generator the follow-
ing power rating is required:
AXT 2200 HP — 3.5 kVA/2800 W
AXT 2500 HP — 4.0 kVA/3300 W.
E. g. Bosch generator units G-3600-series.
An extension cable with a small cross section re-
duces the performance of the machine. For cable
lengths of up to 25 m, a cross section of
2
3 x 1.5 mm is required; for cable lengths over
25 m, the cross section must be 2.5 mm
Always place the machine on solid, level
ground. Do not tilt or move during opera-
tion.
Remove earth from roots. Foreign material such
as stones, glass, metals, fabrics or plastics must
not enter the feed opening. Otherwise this could
damage the cutting roller 13.
12
Initial Operation
The rotational direction switch 2 must be in the
position to the right. The feed opening 6 must be
empty.
Switching on:
Set the on/off switch 1 to "I".
Switching off:
Set the on/off switch 1 to "0".
The motor will coast after switching off!

Restart Protection

A mains failure causes the on/off switch 1 to re-
turn to the "0" position. The machine cannot re-
start on its own when the power returns.
Rotational Direction Switch 2
Before switching the rotational direction, always
switch the machine off and wait until it stops.

Overload Protection

Overloading (e. g. blocking of the cutting roller)
causes the machine to stop after a few seconds.
The on/off switch 1 springs to the "0" position.
Switch the rotational direction switch 2 to the left
2
position (backwards) and after a short period re-
.
start the machine.
Right position: The cutting roller
pulls in and mulches the mate-
rial.
Left position: The cutting roller
runs backward and
jammed material.
frees