Bosch AXT 2200 HP Manual Del Usuario página 11

EURO • Printed in Germany • BA F016L69647 • AXT 2200 HP / AXT 2500 HP • GB • OSW 05/99
AXT 2200/2500 HP - Buch Seite 13 Mittwoch, 14. Juni 2000 8:09 08
Operating Instructions
To collect the mulched material, hang the carrying
straps of the collection sack 11 on the hooks 7 on
both sides of the machine.
Insert material to be mulched. The material will be
fed by the cutting roller 13 without further assist-
ance.
Longer material standing out from the
machine could lash out when being
pulled in by the knives! Please keep at
safe distance!
Insert only as much material as can be fed without
stuffing the feed opening 6 does not become
stuffed.
Mulch withered, moist material and garden waste
which has been stored for some days alternately
with branches.
This prevents the cutting roller 13 from clogging.
Do not mulch soft waste without solid substance
such as kitchen waste. This material should be
composted directly.
The mulching of dry hardwood branches with the
maximum allowable diameter is also possible with
a sharp cutting roller 13.
Pressure Plate Adjustment
The pressure plate 12 is factory adjusted and
does not require adjustment before the first use.
Adjustment of the pressure plate 12 is necessary
as a result of wear (mulched material, e. g.
branches, hangs together as a chain):
Place the rotational direction switch 2 in the posi-
tion to the right and switch on the machine.
With the motor running, turn the adjustment
knob 8 (if necessary, using the Allan key 9) one
notch to the right (clockwise), until grinding
sounds can be heard (the cutting roller 13 cuts
the pressure plate 12 to the proper clearance,
some aluminium shavings fall out of the ejection
chute 10).
Readjust only to the required extent, otherwise
the pressure plate 12 could wear unnecessarily.
9
Garden waste does not feed by itself:
• The cutting roller 13 is running backward:
• The material to be mulched is soft and wet:
• The material to be mulched jams in the feed
Thick branches are not pulled in:
• Check cutting roller 13: If heavily worn, it must
Mulched material is not completely separated
and hangs together as a chain:
• Adjust pressure plate 12 (according to Section
• If the pressure plate 12 can no longer be ad-
Motor does not run:
• The overload protection has tripped: Place ro-
Direction of rotation switches automatically:
When the machine is suddenly blocked (e. g. ow-
ing to accumulated mulched material), the direc-
tion of rotation of the cutting roller switches auto-
matically. In this case switch the machine off, wait
until it stops and switch it on again.
8
12 13
Malfunctions
Before switching the rotational direc-
tion, always switch the machine off and
wait until it stops.
Switch rotational direction.
Push into machine with a piece of wood or
change to mulching branches.
opening 6: Place rotational direction switch 2 in
the left position to free the material.
be replaced.
"Pressure Plate Adjustment").
justed, it must be replaced.
tational direction switch 2 in the left position
(backwards) and switch on the machine again.
Then switch the rotational direction back to
"right".
Check the house fuse. The circuit must be pro-
tected with at least the following fuse sizes:
AXT 2200 HP = 10 A; AXT 2500 HP = 16 A.
13