Maintenance And Cleaning - Bosch AXT 2200 HP Manual Del Usuario

EURO • Printed in Germany • BA F016L69647 • AXT 2200 HP / AXT 2500 HP • GB • OSW 05/99
AXT 2200/2500 HP - Buch Seite 14 Mittwoch, 14. Juni 2000 8:09 08
Cutting Roller is blocked
1. Place rotational direction switch 2 in the left po-
sition, switch machine on. The cutting roller 13
runs backwards and releases the mulched ma-
terial (or foreign material). A special gear con-
struction with rotational angle play allows the
motor to start in the opposite rotational direc-
tion even if the cutting roller 13 is blocked. It is
not necessary to loosen and readjust the pres-
sure plate 12.
2. When the caught material is free, switch off
machine, set rotational direction switch 2 to the
right position and switch back on.
3. If the blocking cannot be eliminated by
actions 1 and 2, the cutting roller 13 must be
removed, checked for damage, and cleaned as
described in section "Exchanging the Cutting
Roller/Pressure Plate".

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
The shredder should not be cleaned with high
pressure cleaners or running water.
The tightness of the attachment screws for the
transport stand should be checked from time to
time.
The cutting roller 13 and the pressure plate 12
have a life expectancy of several years under nor-
mal usage and when adjustment according to in-
structions.
Before storing the machine, remove the cutting
roller (as described in the Section "Replacing the
Cutting Roller/Pressure Plate") and clean. Then
treat the cutting roller with preservation spray (Ac-
cessory, Order No. 1 609 200 399) and grease
the bearings.
For all correspondence and spare parts orders,
always include the 10 digit order number from the
nameplate of the machine!
14
Exchanging the Cutting Roller/
Pressure Plate
Before any work on the machine itself, pull
the mains plug.
• Disassemble the cutting roller 13/Pressure
plate 12 according to fig. E, sequence
• Clean the cutting roller 13.
• Clean and grease the bearings.
• Reassemble the individual parts in the se-
quence – .
• Afterwards turn adjustment knob 8 to the right
until grinding sounds can be heard and some
small aluminium shavings fall out of the ejec-
tion chute 10. In case of stiffness of the adjust-
ment knob 8, e. g. due to dirt, loosen it with aid
of the Allan key 9.
The following exchangeable parts are available:
Pressure plate Part No. 1 601 000 001
........................
Set of parts
subject to wear Part No. 1 607 000 821
......................
(Pressure plate and cutting roller)
If the machine should happen to fail despite the
care taken in manufacture and testing, repair
should be carried out by an authorised customer
services agent for Bosch power tools.
Transport Protection
When
without the stand, al-
ways use the transport
safety
– .
transporting
piece!