Installation; Mounting To Ceiling - ETI Solid State Lighting GROW ELITE GEGL-30WHU-FS Guía De Uso Y Cuidado

Installation

Select a suitable location that can support the weight of the LED Plant light. The light must be mounted a minimum of 8 inches from
adjacent lighting equipment and from materials including, but not limited to, walls, ceilings, movable partitions, and other combustible
materials.
NOTE: When determining the desired location for suspension mounting the light fixture, make sure the light fixture is located directly below
the electrical outlet and that the distance between the electrical outlet and the end of the light fixture is less than 10 ft.

Mounting to Ceiling

Mark two spots on the ceiling 19.68 in. (500mm) apart for suspension mounting before the installation.
1
Mounting to wood
□ Drill two 1/16 in. diameter holes in the ceiling.
□ Tighten the hook screw (B) into the wood.
3
Attaching the V hooks (C)
□ Pierce the V hook (C) through one end of the mounting
chain (D).
□ Then attach to the hook screw (B) on the ceiling.
D
C
B
C
B
D
2
Mounting to drywall
□ Drill a 1/8-in. pilot hole into each of the screw locations
marked on the ceiling. You can also use an awl or nail to
dimple the screw holes.
□ Install a drywall anchor (not included) and a hook screw (B)
in each drilled mounting hole.
4
Attaching the plant light (A)
□ Slide the V hook (C) through the mounting holes on the plant
light (A).
□ Plug the power cord (E) into the end of the plant light (A)
and then plug the other end of the power cord (E) into an
electrical outlet.
CAUTION: Attach the power cord to the chains (D) with
cable ties (not included). Secure the power cord to the
ceiling using cord clips (not included), if applicable.
□ Use the power switch to activate the fixture.
C
4
Dry anchor
(not included)
B
Power
switch
A
C
E