Publicidad
Idiomas disponibles
Idiomas disponibles
8
PARTS AND INSTALLING THE CONTROLLER
7
After fixing the power cable, press the upper
part of the controller toward the back cover as
shown in the figure to fix it.
Top Cover
NOTE
• Failure to follow the guidelines may result in part
damage due to interference with the mechanical.
Be careful not to let the cable pass over the
wireless equipment.
• Arrange the lines in three ways, depending on
cable hole location as shown in the figure 2.
8
Place top cover on back cover and gently press
to close.
9
Close the cover at the bottom.
Wall
Using Group Control
Control by connecting 2 to 16 air conditioner indoor
units 6 to one wired remote controller.
GND
Signal wire
DC 12 V
NOTE
• Connect using the group control cable.
(Model : PZRCWRCG3)
• When using the group control, some advanced
functions (excluding basic operation setting, fan
speed, lock, and time setting) may be limited.
1
Set one indoor unit to master and the remaining
to slave.
#3 switch OFF:
Master (Factory
default setting)
NOTE
• For ceiling cassette and duct products, change the
switch setting of the indoor PCB as above.
• For wall-mount type and stand type product,
change the master/slave setting with the wireless
remote controller
2
After completing the master/slave setting, turn
off the power of the indoor unit, and turn on the
power after 1 minute.
NOTE
• 2-Remo function is not supported.
GND
Signal wire
#3 switch ON:
Slave
Publicidad
