DeWalt D21710 Manual De Instrucciones página 7

Taladro percutor de 1/2" (13 mm) con velocidad variable reversible
Ocultar thumbs Ver también para D21710:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FIG. 2
Selecting the Operating Mode (Fig. 2)
The tool can be used in two operating modes:
Rotary drilling:
for steel, wood and plastics.
Percussion drilling:
simultaneous rotating and impacting for concrete and
masonry drilling operations.
Select the required operating mode by rotating the mode selector
(D) to the required position.
Inserting and Removing a Bit (Fig. 1)
KEYED CHUCK
1. Open the chuck by turning the sleeve (I) counterclockwise and
insert the bit shank.
2. Put the chuck key (J) into each hole in the side of the chuck and
turn clockwise until tight.
To remove the bit, proceed in reverse order.
Fitting the Side Handle (Fig. 1)
The side handle (F) can be fitted to suit both right-hand and left-
hand users.
WARNING: Always use the drill with the side handle properly
assembled.
1. Loosen the side handle.
D
– For right-hand users, slide the side handle clamp over the
collar behind the chuck, handle at the left.
– For left-hand users, slide the side handle clamp over the collar
behind the chuck, handle at the right.
2. Rotate the side handle to the desired position and tighten the
handle.
Setting the Drilling Depth (Fig. 3)
1. Insert the required drill bit into the chuck.
2. Slacken the side handle (F).
3. Fit the depth adjustment rod (G) through the hole in the side
handle clamp.
4. Adjust the drilling depth as shown.
5. Tighten the side handle.
Forward/Reverse Slider (Fig. 1)
To select forward or reverse rotation, use the forward/reverse
switch (C) (see arrow on tool).
5

Publicidad

Tabla de contenido
loading

Tabla de contenido