Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad página 31

Fig. 31
No-Hand Zone
6˝
(152 mm)
The "No Hands Zone" for all slide and miter right
cuts (Fig. 32).
Fig. 32
The "No Hands Zone" for all slide and miter left
cuts (Fig. 33).
Fig. 33
6˝ (152 mm)
6˝ (152 mm)
With all bevel cuts the "No Hands Zone" extends
vertically up to the bottom of the upper guard
when the head assembly is in the lowest cut po-
sition (Fig. 34).
Use sliding fence outside No Hands
Zone
Use sliding fence (Fig. 35, 12) and additional
workpiece supports to properly support the
16099221PJ GCM18V-10SD OSI 20220506.indd 31
Preparing for Saw Operations
6˝
(152 mm)
6˝ (152 mm)
6˝ (152 mm)
-31-
Fig. 34
N o - H a n d
No-Hand
Tool
Blade
workpiece and hold or clamp it outside of the
"No Hands Zone" (Fig. 31, Fig. 32, Fig. 33, Fig.
34).
Workpiece can be held against table (Fig. 35,
22) and fence (12) by hand only outside of the
"No Hands Zone."
• Hold workpiece firmly against table and
fence to prevent movement.
• Keep hands in position until trigger has
been released and blade has completely
stopped.
• Never place hands on mechanism compo-
nents.
• Keep feet firmly on the floor and maintain
proper balance.
• Follow the miter arm when mitering left or
right. Stand slightly to the side of the saw
blade.
Fig. 35
42
12
Bevel
Angle
Upper
Guard
Table
Top
Z o n e
Zone
Lip
26
22 Workpiece
5/6/22 11:42 AM