Sliding Fences; Long Workpiece Support; Additional Workpiece Support - Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad

5. Move saw head up and down and forward
and back to be sure it clears the clamp.
Other Clamps – Other hold-down devices such
as C-clamps can be used to hold the workpiece
firmly against the table (Fig. 37, 22) and the
fence (12). Make sure the clamps are clear of
the cutting path.
Fig. 37
12
22

Sliding Fences

To provide sufficient spac-
ing (minimum 6") from hand
to saw blade, extend the sliding fences (Fig.
37, 12) when making extreme bevel, miter, or
compound cuts.
Operating Sliding Fences
1. Loosen the sliding fence lock knob (Fig. 37)
counterclockwise ½ turn to loosen fence.
2. Slide fence (12) to the desired position.
3. Tighten the lock knob clockwise to lock slid-
ing fence position.
Removing Sliding Fences
The sliding fence (Fig. 37, 12) may need to be
removed when preforming extreme bevel cuts
and most compound cuts.
1. Loosen the sliding fence lock knob (Fig. 37)
counterclockwise 6 rotations.
2. Lift and remove sliding fence (12).
16099221PJ GCM18V-10SD OSI 20220506.indd 33
Preparing for Saw Operations
Sliding
Fence
Lock
Knob
40
-33-

Long Workpiece Support

Long workpieces have a ten-
dency to tip over unless
clamped down and properly supported from
underneath.
Do not use another person
as a substitute for a table
extension or as additional support. Unstable
support for the workpiece can cause the blade
to bind or the workpiece to shift during the cut-
ting operation, causing you to contact the spin-
ning blade.

Additional Workpiece Support

Always ensure that support-
ing surfaces are able to
properly support the workpiece and allow for
secure holding by hand outside of the "No
Hand Zone", or clamping with a clamp inside or
outside of the "No Hand Zone." (See "Body
and Hand Position" on page 30 for the "No
Hand Zone" and the appropriate hand posi-
tions.)
Be aware of the path of the
saw blade. Make a dry run
with the battery pack disconnected and the
saw switched OFF by conducting a simulated
cutting cycle, and observe the projected path
of the saw blade. Keep hands at least six (6)
inches (152mm) away from the projected path
of the saw blade.
Blocks – Long pieces need extra support. The
base height (3-1/2" / 89mm) is designed to
match the standard lumber of one 4x or two 2x.
Boards of these thicknesses can be used to cre-
ate auxiliary support extensions for long work-
pieces (Fig. 38).
Fig. 38
Add one
4x or
two 2x
28
26
5/6/22 11:42 AM