Bosch GCM18V-10SD Instrucciones De Funcionamiento Y Seguridad página 47

Miter and Bevel Settings for Standard Crown Molding Cuts
Assumptions: Molding is milled consistently. Corner is exactly 90°.
NOTE: Always place top
edge against fence
Inside Corner
Left end (Fig. 55, A)
Use the left end of the cut
Right end (Fig. 55, B)
Use the right end of the cut
Outside Corner
Left end (Fig. 55, C)
Use the left end of the cut
Right end (Fig. 55, D)
Use the right end of the cut
Fig. 55
Inside
corner
16099221PJ GCM18V-10SD OSI 20220506.indd 47
Saw Operations
(With Molding Flat on Table)
Molding
Spring Angle 38°
Miter (Table)
Setting
31.6° Right
31.6° Left
31.6° Left
31.6° Right
Outside
corner
Ceiling
52°
38°
38/52° crown
molding
38° spring angle
-47-
Spring Angle 45°
Bevel (Tilt) Miter (Table)
Setting Setting
33.9° Left 35.3° Right
33.9° Right 35.3° Left
33.9° Right 35.3° Left
33.9° Left 35.3° Right
Fence
Table
Ceiling
45°
45°
45/45° crown
molding
45° spring angle
Molding
Bevel (Tilt)
Setting
30° Left
30° Right
30° Right
30° Left
Top of
molding
against
fence
5/6/22 11:42 AM