How To Use - UFESA Thunder Manual De Instrucciones

6. Digital Display
The Digital Display shows the time and temperature in alternate turns.
It shows set time and temperature during setting and the remaining time and cooking
temperature during cooking.
Check the correct time and temperature for the corresponding pan.
7. Start Buttons
Touch the start buttons to start cooking.
Use the correct start button for the corresponding pan.
8. Stop Buttons
Touch the stop buttons to stop cooking at any time during cooking process.
Use the correct stop button for the corresponding pan.

HOW TO USE

1. Connect the supply cord plug into a mains power outlet socket. The appliance is now in
standby mode.
2. Place the ingredients into the pans.
Do not fill more than 2kg food in each basket.
3. Slide the pans back into the appliance.
CAUTION! Do not touch the pans during use or immediately after use, as the pans gets
very hot during and after cooking. Only hold by the handle.
4. Touch the power button. Select the pan to set the cooking process.
5. Select a preset function or set the time and temperature manually for the pans one by
one. Then touch the start buttons to start cooking.
6. For cooking of some ingredients, it may require turning the contents in the basket or ad-
ding small quantity of oil in the cooking ingredients during the cooking process to ensure
even cooking and avoid charring of ingredients positioned at the top of the basket. When
this is needed, you can pull out the pan. The appliance will stop heating automatically. Af-
ter turning or adding oil, place the pan back into the appliance to resume cooking.
NOTE: You may slide out the pan to check at any time during the cooking process. The
appliance will pause when the pan is taken out or powered off. The appliance will continue
the cooking process if the pan is slide in and it will power on again.
7. You can reset the time and temperature setting during the cooking process if required.
8. When you hear the "beep-beep" sound, the set time is elapsed, and the cooking cycle is
completed. The appliance is now in standby mode.
9. Check if the ingredients are cooked to your satisfaction. If not, set the timer for a few
more minutes until the ingredients are cooked to your satisfaction.
10. Remove the pan from the appliance. Only hold by the handle as other surfaces will be
hot. Place the pan on a flat, firm, and heat-resistant surface. During the cooking process,
oil from food will drip and be collected on the bottom of the pan. This can be cleaned at the
end of the cooking process when the pan cools down.
11. After using your appliance, remove the plug from the wall socket immediately and allow
the appliance to cool down completely.
21