Descargar Imprimir esta página

Craftsman 247.77366 Manual Del Operador página 19

Publicidad

Idiomas disponibles

Idiomas disponibles

6.
Remove hex screw on top of rear housing near mounting bracket
and the flange lock nut that secures flail screen. See Figure 20.
7.
Remove and clean the screen by scraping or washing with water.
See Figure 21.
8.
Reinstall the screen.
Warning
Before performing any type of maintenance on the machine, wait for
all parts to stop moving and disconnect and ground the spark plug
wire. Failure to follow this instruction could result in personal injury or
property damage.
DriVe ConTrol Cable aDJUSTMenT
Adjust the drive control cable if the yard vacuum does not self propel
with the drive control engaged, or if the unit hesitates while the engine
maintains the same speed after approximately 20 hours of use.
To move the z-fitting of the drive control cable from its factory set
position in the front hole of the drive control to the rear hole, proceed
as follows:
1.
Push the right side of the control out of the right hole in the upper
handle. See Figure 22A.
2.
Pivot control down towards the lower handle.
3.
Pivot straight up to remove it from the left hole in the upper
handle. See Figure 22A.
4.
There is now sufficient slack in the drive control cable to grasp the
z-fitting with your hand and move it from the front hole to the rear
hole of the drive control. See Figure 22B.
IMPORTANT: Make sure to insert the z-fitting into the rear hole as
it was inserted in the front hole, that is from the outside of the drive
control.
5.
You may now carefully reinstall the drive control by performing the
previous steps in the opposite order and manner of removal.
IMPORTANT: Once assembled and prior to restarting, make sure that
the cable is properly adjusted. With the drive control disengaged, the
unit should freely pull in reverse.
SERVICE AND MAINTENANCE
A
B
19
Figure 21
1
2
3
Figure 22

Publicidad

Solución de problemas

loading

Este manual también es adecuado para:

675 serie247.77013.0