Proceed As Follows; Chapter 18 - Troubleshooting - Lavorwash SWL R 1000 ET Manual De Instrucciones

In the event of any emergency situations such as, for instance: the machine has accidentally been
driven over power cables and these have wrapped around the central brush or side brush, or an
unusual noise is heard coming from inside the machine or engine, hot materials, inflammable liquids,
chemical materials in general, poisons etc. have been picked up ETC:
1) Disengage the traction
2) Hardly press the brake pedal
3) Switch off the engine by the key on the dashboard or simply by leaving the driving seat as the
safety micro switch under the seat will automatically turn the engine off.
4) After picking up the above materials, remove the
and clean it, wearing gloves and mask to protect the airways. Follow the instructions
in the "collection bin" paragraph.

CHAPTER 18 - TROUBLESHOOTING

Two basic faults can effect: the machine raises dust during use, or leaves dirt on the floor; causes could be
many but if the machine is carefully operated and routine maintenance is properly carried out, such faults will
not occur .
FAULT
The machine raises dust
The machine leaves dirt on the
floor
The machine battery is not
performing properly. The
machine is slow and does not
clean well
The internal combustion
engine doesn't start

PROCEED AS FOLLOWS:

CAUSE
Suction lever is in OFF position
(pulled out)
Filters blocked
Filters damaged
Filters badly fitted
Side seals damaged
The central brush is not well set or
is worn
Wires, strings etc. have been picked
up
Side seals damaged
Collection bin full
Battery flat or not completely
charged
The battery charter is not that
recommended or is not enough
Oil level too low or not at
maximum .
Micro-seat not activated .
41
container (bin) part. 1 and 2 fig. 7
REMEDY
Turn to ON position (pushed in)
Clean them by "shaking" them
using the provided tools and if
necessary take them off and clean
thoroughly
Replace
Fit with the seal provided and make
sure they are well inserted and
uniformly well-secured
Replace
Ad just the central brush and check
the "track"
Remove them
Replace
Empty
Check the level of the electrolyte
and procede with complete new
charge cycle
Use a proper battery charger
Top up
Check